KWALA GRIP GLUE GEL
KWALA GRIP GLUE GEL has been formulated to give you the best bonding between grip and bars.
10ml tube, enough for 2 pairs of Kwala grips.
SUPER STRENGTH, GEL FORMULA, ANTI DRIP NO MESS.
1. TO OPEN TUBE :
Screw on nozzle firmly. The nozzle will puncture tube.
Cut nozzle end for you prefered flow rate out of tube.
2. HOW TO USE :
Make sure surfaces are clean and dry. Ideal for other bike part repairs as well.
Warm new Kwala hand grips in sun for 10 minutes
Apply 1/4 (2.5ml) of Kwala Grip glue to the inside flange end of the each grip,
while squeezing glue tube lightly and rotating grip in your hand to complete
a full rotation of the grip.You need to install each grip immediately after
applying glue on the inside of each grip.
You only have a few minutes to mount as drying is starting. Quickly slide grip
on to handlebars twisting up the handlebar until completely on.
Rotate grips when on handlebars 1/4 of a turn back to evenly spread glue on
inside of grip to handlebar and to the correct rider postion for your preference.
Kwala Racing holds no responsiblity of incorrect mounting applications to
3. Wipe of any surplus glue at the flange end of the grip and handlebar.
4. Allow 8 hours to dry for a full cure at room temperature.
Do not move within drying period for best results.
5. After drying period, make sure grips feel secure and make sure your twist grip
turns freely . If it is sticking while twisting, remove with a sharp bladed knife.
We still recommend wiring grips incase of incorrect bonding has happened.
Click below link for KWALA GRIP GLUE SAFETY DATA SHEETS
Find Similar Products by Category
Customers also viewed